Shooting Star 2 axis DRO

[deere_x475guy]

Hi gang, I haven't put this on Ebay yet but thought I would list it here. This is the one I just took off my 13 x 40. It works just the same as it did new. I have the manual and all the hardware that came with it when new. I will post pics of it later this evening when I get home.

Please note that this is an older model. When you turn it off you loose your count direction settings, radius/diameter setting and datum points. I usually just left it on till I was done with the part.

I am asking $300 plus shipping for it.

 

[Paswest]

Do you have picture of it?
Alain

 

[deere_x475guy]

Alain, here are some of it when I had it on the lathe. I will take some pics this evening with it off and post those also

 

[deere_x475guy]

Here it is ready to go in the box for shipping.

This is in the inch mode

This is metric mode, you can see the indicator light on the left

This is in Diameter mode, you can the indicator light at the bottom ctr

 

[deere_x475guy]

The DRO has been sold.