- Joined
- Aug 22, 2007
- Messages
- 193
- Reaction score
- 1
Ernie, I have a question about drawing a line in degrees. I can do pretty well with 2-D stuff and I had to reload about 6 months ago and if I remember correctly in the status bar where it shows your x,y position it used to show degrees also. I have not been able to get that back. If I need to draw a line a certain degree now I have to guess at it , dimention it and then make corrections to get it right. I am pretty sure it is a setting but I cannot find it. Can you help me out on this???
Thanks,
Julian
Thanks,
Julian