Making an Atlas 10F Steady

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
If you enclose the image URLs in
tags all the photos will appear in the posts, like this. Easier to view.

Nice job.

Humph7ey said:
I just finished this in three days including casting. All the machining was done on the Atlas.
Steady007.jpg

Steady006.jpg

Steady004.jpg

Steady008.jpg

Steady005.jpg

Humphrey

 
I just drilled a drawbar hole 400mm long using it. I had a droken piece of 12mm drill that I welded with nickel rods (for cast iron) to a length of 5/16" rod. I had to drill it from both ends but it met in the middle perfectly. Probably helped to bore the first half inch the same size before drilling the actual hole.
Thanks for the img help.
Steady009.jpg

Steady010.jpg
 

Latest posts

Back
Top