Sshire
Well-Known Member
- Joined
- Jun 29, 2011
- Messages
- 936
- Reaction score
- 259
I'm moving up to a larger lathe and thought I'd see if there's any interest here before I Craigslist or eBay it.
Located near Philadelphia, PA
Grizzly G0602 Metalworking Lathe
Purchased new July 2011
With
3-jaw chuck
4-jaw chuck
Faceplate
Steady rest (never used)
Follow rest (never used)
Complete set of change gears (used once))
Live center
Dead center
Lathe dogs
Phase II QCTP (AXA) with 15 toolholders
New motor - 1 ½ hp 220v (larger than original) with TECO FM-50 VFD (110 v)
Lathe is continuously variable speed
Original 2 bolt compound clamp replaced with 6 bolt compound clamp
Digital RPM/SFM readout
Tailstock DRO
Tailstock locking bolt replaced with locking handle
Carriage locking screw replaced with locking handle
Independent, variable speed, carriage feed with Pyramid 12v power supply
Lathe is on heavy duty legs and bolted to hardwood, butcher block top
All manuals
If interested, PM me with a reasonable offer.
Sent from my iPhone using Model Engines
Located near Philadelphia, PA
Grizzly G0602 Metalworking Lathe
Purchased new July 2011
With
3-jaw chuck
4-jaw chuck
Faceplate
Steady rest (never used)
Follow rest (never used)
Complete set of change gears (used once))
Live center
Dead center
Lathe dogs
Phase II QCTP (AXA) with 15 toolholders
New motor - 1 ½ hp 220v (larger than original) with TECO FM-50 VFD (110 v)
Lathe is continuously variable speed
Original 2 bolt compound clamp replaced with 6 bolt compound clamp
Digital RPM/SFM readout
Tailstock DRO
Tailstock locking bolt replaced with locking handle
Carriage locking screw replaced with locking handle
Independent, variable speed, carriage feed with Pyramid 12v power supply
Lathe is on heavy duty legs and bolted to hardwood, butcher block top
All manuals
If interested, PM me with a reasonable offer.
Sent from my iPhone using Model Engines
Last edited: