Discussion in 'Photos and Videos' started by Tapsa, May 27, 2019.
My new project will take time, a year or two, I don't know.
Hi Tapsa .
That is Great Project !
I got a question, what engine do you use ?
I don't know the correct engine name in English, but I would assume a hot plug motor
Crankshaft parts complete
Did you silver soldered crank shaft parts?
I haven't had time to do it yet but I
Not so many parts are ready compared with the time used
Hello everyone, has been busy for two weeks. I haven't had a workshop at all. I was a Speedway race in Latvia. from the video you can see Latvian competitions. I do not run a race, I'm only sponsor of the team.
Today I was able to do some parts again
In another life, many, many years ago (1968 ), I had the opportunity to run a couple Speedway races in Orange County, California.
As a flat track rider, I thought I was prepared to run competitively, and while I finished third on my first attempt, I didn’t have sponsorship, and was using a loaned bike (J.A.P. On a Hagon frame). That was an expensive sport, and as a teenager, beyond my financial capability to continue!
Thanks for the memories!!!
Sorry for the hijack, but I had to comment on the Tapsa post.
Speedway races were popular in 1968 in Czechoslovakia . I was big fan .
I have built little JAWA ESO speedway engine to remind my youth.
Fantastic! Any more pictures?
Hello kadora Have any drawings on your engine. I would be very interested in buying. Thank you for the great picture of the Jawa engine.
Thank you guys.
My thread to Eso engine
Hey everybody. Fuel tank and other small parts, I had time to do
Great work am following along with joy,its a pity there is not alot of model tractors being made,maybe this will start a lanz trend to make them,keep it up.
Thanks, I'm so busy with my work and can concentrate on this only on weekends, if even then.
Very nice Project, will follow it for sure.
About the gear, are you sure you used the right cutter?
It´s marked as #7 55-134 teeth. For a ten tooth gear it should be cutter #1
The gear (tooth) doesn´t look Right to me.
Separate names with a comma.