Kiwi Mk2 Engine

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
The Dormier reamer worked out fine. Drilled the hole 1/64" off the centre and reamed it. Trial fit in the rocker arms and all seems OK. Most probably will do the 3mm studs for the bushes.
can i ask y are the holes off center i new to this site .. is it so u can get your vale tappet Clarance
 
The hole is off center so that you can adjust the clearance between the rocker arm toe and the valve.

Vince
 
When I have to bend a tube.......
-close 1 side
-fill it to the top with table salt & shake a bit
-close the top than
-bend it
-open the tube & let the salt coming out

Than you have a beautifull bend.

Barry

Hi Barry,
1. Happy New Year.
2. Learnt a new trick from you,using table salt. Seen old time plumbers
using sand.
 
looks great. I was given one by my father yesterday. It's in a dire state at the moment. I'd love for it to look like yours someday.
 
Thanks. I saw your photos on another website.

Vince
 

Latest posts

Back
Top