Index table for the MJ-189A (Unimat 4 clone)
To complete the MJ-189A I made a index table.
I also have made four index plates (24-30-36-40 holes) .
I have simplify the house and the plates a little (small holes on the side).
This design is a lot easier than the original.
The pin for the holes is more accessible.
Regards ticino (gerlof)
www.geslo.nl
To complete the MJ-189A I made a index table.
I also have made four index plates (24-30-36-40 holes) .
I have simplify the house and the plates a little (small holes on the side).
This design is a lot easier than the original.
The pin for the holes is more accessible.
Regards ticino (gerlof)
www.geslo.nl
Last edited: