I like to do bench grinders

Help Support HMEM:

h7eh7e

Well-Known Member
Joined
Dec 24, 2016
Messages
198
Reaction score
71
Location
Ukraine. Krivoy Rog.

bruski

Well-Known Member
Joined
May 9, 2017
Messages
46
Reaction score
13
Дуже красива і гладка хода машина.
 

goldstar31

Well-Known Member
Joined
Feb 20, 2010
Messages
3,364
Reaction score
1,232
Location
Twixt Tyne and Tees
Well I've been 'commissioning' one with an 80 grit white Aloxite wheel on oe end and a diamond or CBN wheel on the other, I've sort of been grinding old lathe tools on my new Acute tool and cutter grinder.
Too much snow to get into the workshop n
but I'm impressed with the sharpness of these re-furbished lathe tools. Hope to get them in use

Cheers

Norman
 

h7eh7e

Well-Known Member
Joined
Dec 24, 2016
Messages
198
Reaction score
71
Location
Ukraine. Krivoy Rog.

h7eh7e

Well-Known Member
Joined
Dec 24, 2016
Messages
198
Reaction score
71
Location
Ukraine. Krivoy Rog.

MRA

Well-Known Member
Joined
Feb 13, 2012
Messages
242
Reaction score
65
Hi - I have been looking at your work - дуже хороший :) You seem to use 3-phase motors and you have broken the star-point where needed to work them from 220v in 'delta'. I just did this too, to run with a fancy Japanese variable-frequency-drive inverter which I was lucky to buy second-hand. But are you running yours from a single-phase supply somehow, perhaps with those banks of capacitors to synthesise another phase? I am curious.
Mark, Manchester UK
 

Latest posts

Top