Finished Vise Project

[Jack]

Hello Everyone

After seeing several post about a little vise, I thought that I might like to try one. Well I have been working on it for about a month while moving my new surface grinder and shaper into the basement shop. Here a couple of before and after pictures, I am very happy with the way it turned out and with the help of a few new friends it will now take its place on the model shelf of fame.

Thanks for looking:

Jack

 

[kuhncw]

Hello Jack,

Very nice job on the little vise. I like it.

Regards,

Chuck

 

[AussieJimG]

Hi Jack,
I like the idea of mounting it on a square block. It should let you mount it on the machine with a square and save all that mucking about with the DTI. Well done :bow:

Jim

 

[willburrrr2003]

A very nice little vise you have made :bow:

Regards,

Will R Seattle, WA.

 

[Harold Lee]

Jack - Nice looking little vise.... You did a beautiful job and should be proud of it.

Harold

 

[krv3000]

HI all where are you getting the castings from for the vice regards bob

 

[Jack]

The vise castings can be purchased here:

http://www.morrisonandmarvin.com/order.php

The casting are beautiful, the drawings and prints along with building instructions not so much.

 

[Lamachina58]

Beautiful job Jack!

 

[m_kilde]

Hello folks

Been away for a while, I like this little vise too, very nice job :bow:

 

[Ruy]

Very nice job Jack.

Regards

 

[dalem9]

It looks ready to go to work . Wonderful job . Dale

 

[idahoan]

Jack

Nice job on the vise!



Thanks for sharing.
Dave