Pete92
Well-Known Member
- Joined
- Jun 25, 2013
- Messages
- 46
- Reaction score
- 2
Hello, sorry im being a bit of a pain during this CNC conversion. But I am learning a lot. Especially on the wiring side of things.
I hope this will be my final saga in the EMCO Conversion. I have the machines 2 axis moving fine now. All that remains is the Spindle control.
I bought the C6 board as advised on a previous thread. But I cant seem to figure out how to wire this in. I am using a HG07 break out board from CNC4YOU.
Could someone please advise me on how to set up the spindle control using these devices. I feel I could be missing a piece of the jigsaw.
Cheers,
Pete
I hope this will be my final saga in the EMCO Conversion. I have the machines 2 axis moving fine now. All that remains is the Spindle control.
I bought the C6 board as advised on a previous thread. But I cant seem to figure out how to wire this in. I am using a HG07 break out board from CNC4YOU.
Could someone please advise me on how to set up the spindle control using these devices. I feel I could be missing a piece of the jigsaw.
Cheers,
Pete
