DRO's for my Mini-mill

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.


Alex, No monitor. I just read the scales.


Ron
 
ALex Here are the pics.


Mill.jpg




VerticalScale.jpg



SideScale.jpg




SideScale2.jpg

 
Hi

Check out the website for arc euro trade http://www.arceurotrade.co.uk/ (usual disclaimer) I bought my scales and remote read outs from them. From memory the the remote read outs are £30.00.

The readouts fitted to my x1 mill

DSC08276.jpg


The same readouts fitted on my x3 mill

DSC07049.jpg


C heers

Rich
 
Hi

It should work ok. I would get the correct length scales and fit them right from the start. Since fitting mine I haven't had to touch them. I covered the scale with a piece of plastic just held in place with blue tak. Helps to keep the swarf out. The scales are not all that expensive so it's worth considering.

Cheers

Rich
 

Latest posts

Back
Top