Any other Burgher's out there?

Discussion in 'Introduction' started by oldCB, Nov 28, 2019.

Help Support HMEM by donating:

  1. Nov 28, 2019 #1

    oldCB

    oldCB

    oldCB

    Member

    Joined:
    Mar 20, 2015
    Messages:
    5
    Likes Received:
    0
    Am 1 mile from the Allegheny County Airport. Have a Hgr. at Rostraver Airport, that's where my lathe and #12 Van Norman and B&S 510 surface grinder are, have a MaxiMat7 in the cellar at home!
    So plan is to put a DRO on it and begin what for me would be a Major Moon Shot! I'd like to do a 2.3L Ford OHC engine using the model kit as a guide.............It would include casting which I haven't done since High school and that was an ashtray.
    Need winter therapy here to stay sane especially with the tan clown and all going on:mad:

    Forgive I could not help myself................;)

    So I can go out and access the bigger machines during the cold and preform operations if needed......I would like to reach out and meet locally with any other "Burgher's" to do a meet and greet where We could BS about model engineering?
     

    Attached Files:

  2. Dec 5, 2019 #2

    WSMkid

    WSMkid

    WSMkid

    Well-Known Member

    Joined:
    Sep 26, 2012
    Messages:
    81
    Likes Received:
    14
    Those Lima motors have always fascinated me.

    Please post your build if your decide to proceed.

    GJ
     

Share This Page