5 cylinder air motor
- Thread starter stevehuckss396
- Start date
Help Support Home Model Engine Machinist Forum:
Every time I visit, I see incredible work.
Someday I'll have one to show off.
One thing that I have noticed when the engines are run is that they are not fastened to the table. I always worry that someone is going to lose a finger trying to move a running engine.
Safety First.
Someday I'll have one to show off.
One thing that I have noticed when the engines are run is that they are not fastened to the table. I always worry that someone is going to lose a finger trying to move a running engine.
Safety First.
cfellows said:
Thank you!
I hope to see a video of your running soon.
SAM in LA said:
That's part of the fun! Just kidding!
The little thing has alot more torque than i expected but there are no sharp edges. I can touch it when running and not get hurt.
deere_x475guy
Well-Known Member
Nice work Steve, and sounds good to me. How much of this was done with your CNC? I am still hoping to have CNC in my shop.
deere_x475guy said:
I did the rods, master rod, and the crankcase. I rotated the block by hand and the mill made all the cuts.
