Search results

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. G

    Chinese collet sets

    I have found in the Chinese market complete sets of collets ER 11 and ER16 for about $25 and collet holders for $16. The runout they claim is that of the German DINm but is it so? Does anybody have experience on the subject? Grasp the oppportunity to wish all a happy New Year... George
  2. G

    BA Hex bolts - nuts lower prices.

    Am in need of BA 10 and 12 bolts and nuts. Have looked up the price list of my appointed supplier and foun out that prices are almost doubled in the last 2 years. Any info regarding a low (well, lower than others) price supplier will be greatly appreciated. George from a hot Greece
  3. G

    CAD 14 request for help

    Hi people, I am not sure if this is the right place for my request but hope so. I have access and use of CAD 14 and have following question. If 2 blocks overlap how can I make the one on top opaque so that only the top one is visible and what part of the bottom one is not covered by the one...
  4. G

    2009

    Hi people, couldn't find a better place but I hope anyplace is good for wishing a happy New Year or isn't... George from Greece
  5. G

    Merry Xmas and a happy new year

    Hi people, will be leaving (not on a jet plane as the old song goes) for the holidays and wish you all a very happy and productive New year. Please extend my wishes to your families - mean wives - which support our hobby grudgingly, if at all. Till the next year, George
  6. G

    Metric brass tubes suppliers...

    Hi people, wish to find metric brass tubes of 1mm wall thickness in. diam. 2 out. diam. 4 and in. diam. 3 mm and out. diam. 5 mm. (Did I manage to perplex you ?) Anybody knows where could I find them ? Thanks, George
  7. G

    Electroless (or electric) nickel plating.

    Hi people, anybody knows of a European source for the above ? Will be obliged, George
  8. G

    Bending of thin wall tubes

    According to the seller's claim, the low melting point alloy can fill a tube which is then bent and the alloy easily remelted out... http://www.smallparts.com/products/descriptions/lma.cfm I have done it with ordinary solder but it's not the same. George
  9. G

    A new (66 years old) member

    Hi people, My name is George and I live in Patras - Greece. I made my first diesel marine engine in 1960 and next year a rotary valve single cylinder steam engine. They both had a horrible end. The first after working for about 10 secs started unscruing due to a bad balance and never worked...
Back
Top