Search results

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    Stirling engine formulas

    Goldflash, good info links. many thanks.
  2. P

    Stirling engine formulas

    Thanks! found it, downloaded it.
  3. P

    Stirling engine formulas

    Is there a so called "down and dirty" "rule of thumb" method for determining the bores and strokes of the cylinders and mass of fly wheel for a stirling engine without getting into lengthy calculations. Thanks, ace
  4. P

    Diagnosing circuit board?

    It is always good to learn something and electronics is great. Don't know what your working on but troubleshooting a circuit board can be a major undertaking. I know, I was in avionics for many years. If the circuit board happens to be something you need now I would suggest doing a search for...
  5. P

    Hello from Colorado

    Thanks everyone! Finally got back and answer the question of where I live in Colorado. I live in Gypsum, CO approately 30 miles west of Vail, Co just off I-70. I finally bought a house so NOW I can set up shop. I have been drooling over a of post which really helps with the motivation :) Again...
  6. P

    Lathe and mill

    Being a non-pro machinist I will say yes. I started with a HF 7x10 hoping to make some small engines. Ended up getting a HF mini mill too because I started making some parts for a HD Sportster I rebuilt. Now that is over I am ready to start the original plans. Anyway my minimal experience says...
  7. P

    I can do it

    It neat to find this section in the forums after just joining. I destroyed my right (dominate) hand in a work accident. Lucky after 3 weeks in the hospital and 7 surgeries the doctors were able to save my pinky, ring, and middle finger. Most of my index finger was was unrepairable and was...
  8. P

    Hello from Colorado

    I love your forum, too bad it hastaken me this long to find it considering the amount of net surfing I do. Anyway I live in Colorado, just moved here from Arizona and I still have not unpacked my shop. I don't own anything special or fancy, just the common Chinese made lathe and mill from...
Back
Top