Search results

Thanks, I will look into it. Do you know if there is a way to replace it without tearing apart the saddle?

I own a 13x40 Enco lathe. The oil sight glasses are starting to leak. I would like to replace the sight glass in the gear housing and in the cross saddle. Where do I find replacements? Is the there a way to replace the sight glass in the cross saddle without tearing it apart? Or perhaps is...

I recently bought a 13X 40 Enco lathe with a 3-phase motor. I'm trying to hook up a Teco L510 VFD. I read thru your blog. But appears my factory lathe wiring is a little different than yours. I'm not an electrician. So I'm having a hard time following along. Do you have an e-mail address I can...

Carl, Thanks for the help. I took the front cover off to figure out the wiring for the switch panel. I downloaded your blog post. My wiring appears to be different. I don't have any contractors labeled "KM1" "KM2" or "kM3". So I'm a little lost following your blog. I currently have VFD...

I have an 111-310 enco lathe .model 1340. I would like to hook up before the contractors(maybe called a coil??). But not sure were to tie into it. The schematic that came in the owners manual is pretty much worthless. It only shows the wiring pertaining to R,S,T (coming from the junction box...

Hello to everyone, I new to this site. I recently bought a teco VFD (p/n L510-203-h1-u) for my Enco 13x40 engine lathe. Does anyone have a schematic? I'm a machinist by trade. Not an electrician. So any help would be appreciated. I pulled off the front switch panel. There is a red(activates the...

Hello to everyone, I new to this site. I recently bought a teco VFD (p/n L510-203-h1-u) for my Enco 13x40 engine lathe. Does anyone have a schematic? I'm a machinist by trade. Not an electrician. So any help would be appreciated. I pulled off the front switch panel. There is a red(activates the...