Search results

I did rc airplane modeling for about 15 years. I have a panel, driven by a 12v battery and it's adjustable, but i dobt think he can drive 5 plugs at time. I'll dismantle it and see what i can do. Maybe i'll come up with a simple circuit bord drawing.

Os #F glow plug. Someone got a dawing of a good glow plug driver???

Getting close

Did the cam housing. I will have to redo it. I did a dumb mistake when i took the G54.

Did those little button this morning. I guess i will get used to smalls parts ;-)

Just got the plans, is there someone here that did this engine??

Almost look like an engine ;-)

Almost done. I have to do the small 0.050" oil hole tomorrow.

Working on the case today. I'll try to make a little video without cooling fluid.

No way!! ;-) It Happen to the best of us!!!

Crank assembly.

CamGear done too. Wire EDM.

So, i did the first step of the crank. I tried to do it one shot but i had vibration problems and i was not able to hold the part like i wanted to. This one is good, i have +0.001" on every diameter, will test fit with bearings as soon as i get them. I should do the second step and the counter...

Yeah, i did it one pièce, too much material to remove.

Crank is done but not good. I had problems with the second chuck on the mill turn and the part was scrap anyway. I did the other step on the dmu 50, went good but the part moved in the chuck... So, i will have to make some kind of jig or i'll will do it in 2 parts. Making it one part take LOTS...

Yes, thats what i figured out. He putted the carbs lower than the bottom tubes to avoid that.

Those who say it's easier on cnc, just dont know what they are talking about.

Idler gears. Wire edm.

Yes, it's the original geometry. I only removed some material around the holes.

This is the setup.