Search results

Great Job thanks for sharing! Rick

Spoke with Roy and ordered the CDI ignition system will have it next week. Hope to get the tractor to fire up! thx all

Thx sent an email and have a call into them also. Hope to get one that will replace what I have and is a direct connect using the points that are mounted now. Thx everybody will post updates if and when its up and running!

Thats where I need the help I'm not sure what is meant by S/S unit (Solid State I Assume ) Where would I get one with full instructions on how to wire it up? Thx

Yes it water cooled just took it all apart and cleaned the little vane pump. thx for the info! Rick

I'm in need of some direction as I need a new ignition System for this mini Tractor Motor it has a set of points Condenser and a coil from a lawn mower (the coil is bad) this was used to provide spark to a NKG CM 6 Plug I was using a small 12 volt battery for the coil Which I believe I fried the...

I'm in need of some direction as I need a new ignition System for this mini Tractor Motor it has a set of points Condenser and a coil from a lawn mower (the coil is bad) this was used to provide spark to a NKG CM 6 Plug I was using a small 12 volt battery for the coil Which I believe I fried the...

The photo of mine is with the Sheild open. Its the same as the pic you have when I close it. THX for the imput. Rick

Does any body know if there should be a spring under the whistle to hold the ball down that is acting as a exhaust valve? To be sure that it is being seated on the return stroke? And if I make a new valve for the main opening what material can I use? Steel, cast iron, Graphite etc. Thx Rick

thx and I did and I lapped the surface (Cast steel) and when I tried to get it going I see the flame being sucked into the chamber big time but no luck yet. I need to try the coleman fuel but that may have to wait a few days till I can get some. But thanks all for the help so far and keep the...

thx both I will try that next Coleman and Graphite

Yes very smoothly There is a oiler I tried with and without any oil (3in1) It seems to me just a little longer with the flame. Also when turning it CW I only get a half of turn as to CC its rotates more. Does direction matter? Thx

Also Kel I did get a pic out there You cannot adjust anything on the timing as it is fixed There is a cam follower and the cam is cast in the flywheel hope this answers some questions. Thx

First off I am not sure how to attach a photo And I thought I was pretty computer literate! Yes Chuck you are correct and eveything is free and working as it should the whistle even peeps when I try to start it but it wont run I tried to pre heat the motor even as this is a big piece of cast...

I am very new to this I saw my first flame licker engine a few weeks ago on utube had have one so I purchased this one on ebay it seems to be in good shape (I am a machinist by trade but I now work in clinical engineering in hospital so this means I do not have all the machines at my disposal...