Search results

Is there a way to see if memory overflow is the problem? I am using 1.8.1. I see that the newest is 1.8.5. Also, if I mimic the button circuit on the keypad that you used, I should go back to your original keypad/LCD program instead of Torfollis (sp) right, even though I am using the my LCD...

So, the JgAn if this is set to 1 degree, then each push of the right or left button the table moves 1 degree? If it was working right, to get out of the continuous turn hit the Select button? I think that I am going to build the button circuit on a separate board using industrial quality...

I just tried hooking up the Uno to the stepper driver using the pins the Uno is stuck on in RodW's program(Step pin 1 and dir pin 2), no movement in any function. I went back to Chuck's program and the Gary Liming program, everything works great using their programs. Did this to verify the...

Thanks for the reply. Yes, an UNO. Here what I did on your recommendation , Changed the DIR to 0, changed the STEP to 0, hit Save=yes. After rebooting up, the Dir did change to a 0, but STEP stays at 1. Went into the program IDE as per your advise, in the # define changed STEP_PIN to 0...

Ok, got the buttons to work thanks to Torfilli's(sp) LCD.cpp code. But I need some operator directions as I mentioned previously on the use of the menu's. When I get to the setup menu and go to setup the step pin #, to say pin#2, I change it to from 1 to 2 the up down buttons, then rotate...

I don't know if the buttons are working correctly or not. I don't want a chase a problem that doesn't exist . I need a discussion on the operation of said buttons or a flow chart. I could find no dicussion on the operation of this software from a button operation viewpoint in the three plus...

Very frustrated, can someone please help me?.What is the proper operation of the buttons ( owners manual)? When it boots up it shows divide #... up/down starts. If I push select, it goes though various main menus. What button do I push to select ( lets say configure ). When I push the right...

I did read post#4 previously, which why I knew that it didn't load the library. I had to manually load the library into the java folder. On previous Arduino programs that I have used it loaded the libraries automatically. Your program did load the Eprom library automatically, so I am confused...

Rod, I get the same thing, I clicked the Rotarytable10.ino . Doesn't load the library BoolField.h Any ideas?