Search results

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    Clever wind powered machines

    See here http://www.youtube.com/watch_popup?v=HSKyHmjyrkA Not sure how the friction is kept down on these machines with only light wind to power them.
  2. D

    How to properly advertise in ebay

    This guy has a great story. http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&Item=120704752959&Category=35227 I hope his truck goes to a good new home.
  3. D

    The history of an unusual engine :)>

    Uncyclopedia is a great resource. ;D http://uncyclopedia.wikia.com/wiki/Wanker
  4. D

    Online GPS

    An online location finder http://www.darnay.com/iec/features/locator/index.html It uses your IP address and finds the exact location of any internet user in seconds. They have used a sophisticated time based algorithm to do so. Try it and find your own location on the earth. Your location will...
  5. D

    Missing part for my engine

    Dear All I am currently making a PMR Mill engine 3A as I am describing in this thread. http://www.homemodelenginemachinist.com/index.php?topic=11442.0 I seem to have misplaced the bit of brass that is to be used to make the cross head. It is 3/16" thick and 3/4" square. I don't have any other...
  6. D

    PMR Mill Engine 3A

    Dear All I am only a beginner at making engines. I have successfully made a sterling engine and a wobbler noted here http://www.homemodelenginemachinist.com/index.php?topic=11053.msg120953#msg120953 For my 3rd attempt I am making a PME 3A mill engine from a casting kit that I bought at the same...
  7. D

    PMR 2A Wobbler- my first engine from castings

    Dear All This is my first attempt at making an engine from castings and only my second steam engine. It runs (just) with me blowing into it and easily on a little compressor. I modified the kit a little as it is imperial and all my taps etc are metric. I didn't take any WIP images. I must start...
  8. D

    First Engine. A successful Sterling engine

    Dear All I purchased a 9x20 lathe to make parts to use on my telescope but decided to try to make an engine as practice. I bought a kit of bar stock with plans and the result was a little sterling engine. I am not an engineer but a medico so this has been quite a learning process. Some images...
  9. D

    Kit Boiler

    Dear All I am new here and want a little advice. I am interested on building a small boiler to power little model engines rather than using compressed air. I have found...
Back
Top