Search results

I have only done a dozen threads myself but I like to experiment on pvc first to get the motion and moves down.

I had to drill a lot of holes for my dro on the mills cast iron. It was a piece of cake. My guess bad taps

great idea new to me. thanks

I will take them, I can paypal you for shipping to So. cal.

I just purchased a round ram mill with a J head very clean but a little stiff x and y from being in storage for many years. I paid $500. that was a bargain, Sold my Burke millrite for $1400, I guess it depends on your location but that is a no more then $1100 in So. California. I did not have...

I forgot about that use for the drill press, I have a v shaped dohicky with a vertical shaft and a set of lines to get center, that helps center for the drill press

i installed the accu-remote stainless steel ones on the xy on my mill and work perfect so far. about 3 months.

Great shop and you fellow are something else.

I like the idea and will start doing this. easier than me bringing it all the way against the chuck.

Very nice I like it. especially for what they want for the little clamps they make for low side clamping. I also have some broken up old large bearing housings I use for parallels