Search results

Try RONSON GEARS｜Australia Address: 18 Teton Court, Highett Victoria 3190, Australia Telephone: +61 3 9555 9822 Fax: +61 3 9555 7480 URL: http://ronsongears.com.au/ E-Mail: [email protected] And look up KHK gears.

Hi All Need some info on machining a split eccentic to fit around an axle to run a feed pump, rather than dismantle the loco and quarted drive wheels.:confused: Split eccentrics 101 for dummies :wall: Cheers Hat

Hi All I had the same trouble finding suitable ignition and coils but fond these guys om the net and they posted out to Australia no problems. J E Howell model engine plans Email: [email protected] Phone...

Top job mate and congratz on a first time runner. As per Brians post I am one of those with a runner on youtube "Thompson engine" and a on & off the shelf "Brass T" that I'm trying to get running. It fires and dies ,fires and dies:wall: but so help me it WILL run.:rolleyes: Now that, that...

Putting the rails in under the saw is the easy bit, Getting the roasting tray out of the miss's kitchen is the challenge.

A bit of deja vu I have just rebuilt said machine replacing a couple of fiber gears with alloy ones, new bearings in the quick change g/box, Readjusted head stock, reset gear change forks Etc Etc. After talking with a few old heads and a not so old one Re hard to obtain 10 weight oil all...

Hi Bob Here's a little tip for your band saw. I bolted a couple of pieces of 20x20x1.6 angle onto the legs across ways using the top elongated holes provided and an old roasting dish to make a slide in slide out chip tray. Good luck with your projects

Speaking of Elmers engines I saw a two cylinder wobbler geared to a single shaft presented by Tubalcain on youtube and he suggested it was a number 115? made by Elmer. I would like to get the plans for this if anyone can help. I have searched the John Tom to no avail. Cheers Hat

Speaking of Elmers engines I saw a two cylinder wobbler geared to a single shaft presented by Tubalcain on youtube and he suggested it was a number 115? made by Elmer. I would like to get the plans for this if anyone can help. I have searched the John Tom to no avail. Cheers Hat

Speaking of Elmers engines I saw a two cylinder wobbler geared to a single shaft presented by Tubalcain on youtube and he suggested it was a number 115? made by Elmer. I would like to get the plans for this if anyone can help. I have searched the John Tom to no avail. Cheers Hat

Speaking of Elmers engines I saw a two cylinder wobbler geared to a single shaft presented by Tubalcain on youtube and he suggested it was a number 115? made by Elmer. I would like to get the plans for this if anyone can help. Thanks Mark

What it's worth and what it cost's are only relevant to what the seller want's.

Try www.jerry-howell.com they can supply coils/ leads/ transistor ignition systems either assembled or kit form. They are very helpfull with reliable shipping . I had their TIM-6 sent out here to Australia and will set it up on a Dale Detrich brass " T ".

Brasso and Silvo are household names here in Australia and New Zealand been around since Capt Cook A small dab on a rag and a good rub you'll see your face in the brass / copper.