Search results

Very nice write up Doc. I recognized the Webers right away. Small block Chevy?

I have the black display models, mine do not turn off.

My column reinforcement. Nothing really new here, All ideas came from this forum. but I thought I'd show it anyway.

I'm hoping you can clear something up for Me. I have not received my X2 mill yet so I can not get any dimensions from it. But I would like to get a column support made for it so I will have it already to go when my mill arrives. In your drawing, the 15/16" hole is located 3.250 from the...

Very good start. Thank You

The gears in the head are plastic also. I changed them over to metal using the kit that LMS sells. I'm leaving the intermediate one plastic though for just the reason you mentioned, to act as a shear pin.

This sounds like something I would like to do. Where can I find more info on thid conversion?

That's the one I was looking for, thank you. Good news is that they must have updated the instructions. The ones I received say to place the hole 15" down from the top, which is much closer to your number than the 12" figure they gave You. Thanks again for your reply.

I just received my air spring kit from LMS and am about to install. I read somewhere while researching this mod that the LMS instructions where incorrect as far as where to drill the hole for the lower end of the strut. But, now I can not find that post again. Can anybody shed any light on this...

Is this one any better? http://www.littlemachineshop.com/products/product_view.php?ProductID=3771&category=

Very nice job Brian. Thanks for sharing