I found the problem, ya have to read all the instructions, I used low temp silver solder instead of silver braze so its back to the lathe to make the proper cylinder.
Bob
Here are the two photos. The displacer pin is at 12:00 and the power piston is at 9:00 as viewed from the displacer piston side. I think that is what the article said, bu correct me if I am wrong.
I have completed building the engine but am having trouble getting it to run, I would appreciate any assistance you can give, I think the timing may be off but not sure. It is built to the exact dimension listed on the drawings and it turns over freely. and the timing is the 90 degrees as the...
Even tho the cost was figured on prices 8 years ago I assume Canadian dollars that is about what right for the cost today in US dollars . Of .then you would have to factor in labor and aluminum/brass costs .
I have a friend that ask if I would sell my Webster if not, what it would cost to make one. I had not given it any thought to selling one prior to him asking, and I don't ever remember seeing one for sale. Has anyone sold one? Or seen one priced.
This is the two cylinder that Leon made some time back there were no plans or drawings other than photos so it was reverse engineeredhe has the information
Thanks for the response, I am happy with the Coleman/oil mix never thought to use WD-40 in fact I don't have any in the shop, rely on Kroils for most things. I noticed that getting carried away with the cylinder oiler makes the engine slobber a bit.
Having completed my Webster I was curious if anyone was running theirs on gasoline. I am currently using Coleman lantern fuel with a few drops of Marvel Mystery Oil. If so did the timing change on gas?
I use gas in my Ford engines with no problem but they use cast iron rings as opposed to the...
finally got the engines finished up and running. The Ford 1 aka "kitchen sink" and the Ford 2, altho not a Ford engine but a Leon Ridenour engine as seen at the end of his build dvd.
I have my Webster completed other than the carb. I have a Traxx Pro 15 for it and was hoping someone that uses this one could give me some of the finer points on setting it up and the adjustments.I did a search but there is so much spread over many threads thought I might consolidate the...