My SX3 is fairly well redundant now but I had a 4" vice fitted, did plenty of miles with it.
Some people run a 6" but I reckon they look out of...
It has been a long road. Now the paneling has to be stripped down and all joints sealed with silicone to avoid coolant leaking...
The turret does appear a bit faster than it was originally.
I am running the default motor parameters that Andrew Barrow supplied...
the stepper motors are Nema 34 906 oz in.
The morning over here in the West was massive.
The turnout for the Gosnells service was enormous, Great to see the kids paying their respects...
After much delay I am happy to have taken the first cuts on my machine. I am wrapped with the outcome.
The surface finish and sizing is...
Can't wait to see and hear it run. True craftsmanship once again.
Thanks for sharing.
I will be watching this one with interest
I did this some time ago on BobCad.
Was quite a lengthy task. I did make the rotors on a 4 axis machine, they came out well but have since melted...
Love you'r work Gus.
Nothing beats a good feed of fish
Sounds like the motor driver board has crapped itself, This is common. Probably best to get it diagnosed properly though.
Hare and Forbes can...
Another one from Perth WA.
XD351, I used to have one as well, ex cop car, loved it. I put the 351 crank and rods in, cam manifold...
Just give us a yell when you are ready Simon.
Cogsy you are close to my joint from memory Might be able to hook something up and both visit Simon...
I am keen to give it a crack mate.
1L would be good;
Can drop around and pick up over the weekend if that would be ok
Happy Australia day to my fellow mates
Dam Swifty you beat me too it this year.
Also thank you too all our allies near and far for you'r efforts...
Yes I would be happy to pay $20 for the plans.
I have not built the engine yet but did find the plans very informative and clear, Quite easy to...
G'day from way out West
Merry Christmas from Perth Western Australia.
I wish everyone the very best day with family and a prosperous new year.
This is very cool, I have never seen this type of engine.
I went with sandblasting and powder coating, came up like new and cheap as well. I think from memory it 100 bucks for the lot.
Separate names with a comma.