Search results

Help Support HMEM:

  1. R

    1/4 scale international model M

    I made several engine before this from casting I made, the best way to make patterns is to have something to look at and scale down for the size When it comes to casting it you will have many failures. You should design your pattern for machining so it be held firmly in the mill to start
  2. R

    1/4 scale international model M

    go to you tube and down load MVI1354 1/4 scale international M, to see it running
  3. R

    1/4 scale international model M

    I made one engine using my castings, I always make two sets of castings be cause of its size many parts were fabricated. Its a good running little engine
  4. R

    6 cylinder steam engine

    Hi this engine is my own design the air is feed on the back side to each cylinder this is working ok, the problem is the crankshaft doesn't stay the same as it turns to keep in time. you can see by the picture the rotor is the problem.
  5. R

    6 cylinder steam engine

    I was needing the solution for my engine on the crankshaft does not turn like it should causing it to lose timing any one know the solution.
  6. R

    looking for plans for a steam radial engine

    any one know where I could down load prints for steam engine
  7. R

    Breisch Associated Casting Kit

    the mag works it using peso from a charcoal lighter you have to change the cam and a way to stop it doing the coasting other wise the peso doesn't last, I made it look like a Wico.
  8. R

    Holt 75 from Italy

    sorry I am late with a reply, without a oil ring it spits oil on the engine so I added the tube, for easer clean up
  9. R

    Breisch Associated Casting Kit

    I couldn't tell by your picture witch size you have he made 2 sizes
  10. R

    Breisch Associated Casting Kit

    nice fine, it looks like it has the crankshaft casting that wasn't suppled in my kit. I purchased mine in the 80s
  11. R

    1/4 scale International M

    Here is the patterns for crankcase and cores
  12. R

    1/4 scale International M

    Yes, I made the patterns from wood. I made two cores for the crank case and the base, thanks for the interest. Winter months are a good time for projects.
  13. R

    1/4 scale International M

    I cast the crank case and flywheels then fabricated all remaining parts MVI 1354 1/4 scale international M - YouTube
  14. R

    Chinese model engine problem

    this is their up right model
  15. R

    Chinese model engine problem

    Has any one had any problems with their ignition I received the engine installed the battery's and it worked on test I set it back. when I added fuel I get no spark out of the system
  16. R

    Another Knucklehead Build

    I was studying you plans on the carburetor and I didn't see the float, did you do away with it. The float is a problem to make it light enough to float in fuel. I am eager to see your engine running. Rodue
  17. R

    Does Anyone Weld Their Own Band Saw Blades?

    I have a butt blade welder, but I have tig welded them also
  18. R

    Another Knucklehead Build

    I was too cheep to purchase the bearings, so I increased the size to .25 and replaced it with drill rod roller It dose great a problem on insulation but I have conquered that. I will have to see how well it works. I am going to have to add a spring to the push rod it doesn't want to return...
  19. R

    Another Knucklehead Build

    If time was money us model builders would be rich. I had a good friend when ask, how long did it take to complete that model he's answer was a, " cold winter and a late spring"
Top