Hi to all!
I could not find information on the plans how to time the camshaft with the crankshaft. I tried to do it on my way with my...
I liked how the sandblast finishing come out.
As I said before I plan to sandblast the block and the sides of the heads.
I have sand blasted the timing cover and assembled on the block to check if it is OK now.
Yes, it is OK the hub...
Where do buy the magazines? I'm really interested on this engine.
The new Timing Cover is finished.
The one on the left is the correct one. I will sand blast to give it a cast appearance and eliminate the...
Bob, thanks for the tip. I will try that on the next project.
A very nice fan on your Demon Steve. It must push a great amount of air thru...
Thanks Steve, you are right!
My mistake, did not pay attention when drawing on the CAD.
I will make another Timing Cover. I think shortening the...
Do not worry about imperial, it is just a matter of converting. All my projects are imperial but I work in Metric.
Hi to everybody!
A question/help for those that have built the PeeWee.
Did you guys face the same problem shown on the photos below? The fan is...
Thanks, John. I have learned a lot with the help of the members of this forum.
For the Liners lapping operation, I used a brass lapping bar
I have used a diamond paste for the final finishing. The inner surface...
Here are some more pictures of the progress. It is not in sequence of construction.
Turned the valves
Grinding the valve stem using a...
Hi to all!
Steve, yes I added one more bearing. I had seen your recommendation in another thread and ordered one extra bearing for...
Hi to all!
As I do not like the process of soldering two halves of bronze for the bushings, I turn two complete bushings than machine out to the...
Preparing the blank for the connecting rods.
This is the bottom portion of the connecting rod. I bored all the bolt holes including the small...
The Lifter Bushings and Throtle rod
With the PCV valve
Preparing the blank for the Rocker Arm
[ATTACH] And here is the "All Powered Crankshaft"
Some more details of the Crankshaft on the lathe.
Turning the ends
Machining the counter-weights
Checking out how...
It has already passed several months since my last post on the PeeWe progress. Almost half year. The available time is short.
Very good aproach. I'm also learning CNC programing.
I did the flanges on CNC at one operation. It did work well.
You are right, it is...
Separate names with a comma.