New threads and interesting conversations directly in your inbox. Sign up now and get a daily summary of the latest forum activities!
Have you made certain that the tool is at center height?
With steel make sure you use plenty of coolant.
I would recommend running...
From Google :-
HAYNES® 282® alloy (UNS N07208) is a, wrought, gamma-prime strengthened superalloy developed for high temperature structural...
Did you make sure that the taper was the correct angle and the start and end diameters were correct for the thread form?
If it is a split...
That is a Multi Revolution, Balanced dial: For reading the difference from a reference surface.
Yes, that is a long travel indictator as seen here :-...
Thanks for the tip!
Jus a request but could you possibly mark the todays posts in bold so I can see them easily?
Lift the frame to take the blade out of the cut while the saw is running.
Does the knocking stop?
If it does it is most likely the blade is...
Try lowering the cutter speed, chatter is usually down to rigidity and speed.
See here :-...
The metal is mild steel and yes the surface is very rough but that was using a different tool and a rough cut just to reduce the...
As requested, pics of the new tool in use.
The holders for the square carbide will have the carbide in the far left and right corners...
Thanks to Niels Abildgaard supplying the carbide I have just completed my tangential tool holder.
It works really well and leaves an...
Use the yellow pages to see if there is a local engineering firm with an EDM machine and get them to burn it out.
Souns like just what I need, thanks for the info.:D
I am considering getting a Pyrometer to use for tempering steel but I am not sure if the infra-red types are the way to go.:confused:...
I agree, there is so much waste these days that really should be put to a good use.:(
Good point about the markings on plastic I...
No my thoughts were not elsewhere.:)
I know they are plastic but I wanted to know which plastic was best for a threaded...
Thanks very much for the replies.:D
It sounds as if Delrin would be good for what I need, I'll go for that.
Could I have some advice please on what would be the best plastic to use for a threaded hole?
One that would give good self...
Thanks very much that clarifies the connections.:D
Separate names with a comma.