- Joined
- Jul 31, 2010
- Messages
- 306
- Reaction score
- 70
Polignacs Curved Cylinder Engine
- Thread starter fltenwheeler
- Start date
Help Support Home Model Engine Machinist Forum:
Dr Jo
Well-Known Member
- Joined
- Nov 1, 2011
- Messages
- 166
- Reaction score
- 13
I have built a number of Anthony Mount's engines but not that one. I had hoped to make one but the kits are no longer available.
Anthony wrote up the entire build back in 1995 in Engineering in Miniature and I can remember discussing it with him. The trickiest part he thought was the side frames which are soldered up.
I have seen his engine run.
Jo
Anthony wrote up the entire build back in 1995 in Engineering in Miniature and I can remember discussing it with him. The trickiest part he thought was the side frames which are soldered up.
I have seen his engine run.
Jo
I built two of the engines from scratch. One with one cylinder and one with two cylinders. I used the plans that were published in Engineering in Miniature.
- Joined
- Jul 31, 2010
- Messages
- 306
- Reaction score
- 70
I have Anthony Mount's book around here somewhere. Some very interesting models. I was lucky enough to purchase this engine kit off eBay years ago. I paid as much in shipping from England as for the kit.
Tim
Tim
I've always wondered, just what kind of machine do you need to make a curved piston----Or, for that matter, a curved cylinder.
To make the cylinder you need a curved boring bar!!!
MIKE4444
Active Member
Hi please send details of a curved boring bar also how o use this too l thank you , MIKE
- Joined
- May 15, 2017
- Messages
- 481
- Reaction score
- 298
- Joined
- Jul 31, 2010
- Messages
- 306
- Reaction score
- 70
I will dig the plans out and make a PDF of the tools to make the cylinder.
Tim
Tim
- Joined
- Jun 4, 2008
- Messages
- 3,285
- Reaction score
- 630
I've seen one running at Cabin Fever.
Hello, I made this engine from that kit approx 25 years ago. In my kit the lattice pillars which are placed on both sides of the cylinder were made of laser cut metal sheet and soldered with flanges etc.
The cylinder was a cast part. I manufactured the curved cylinder hole by using a round table on the milling engine. The cylinder was fixed on the round table excentric as required by the radius of the curve. A fly cutter was fixed in the milling head. The cylinder was moved in the rotating fly cutter by swinging the round table. This produces a part of a torus hole
Richard
The cylinder was a cast part. I manufactured the curved cylinder hole by using a round table on the milling engine. The cylinder was fixed on the round table excentric as required by the radius of the curve. A fly cutter was fixed in the milling head. The cylinder was moved in the rotating fly cutter by swinging the round table. This produces a part of a torus hole
Richard
Attachments
I believe the necessary supplies for this sort of engine are sold by the Escher Drawing Co.
