Mery 6-stroke kit.
- Thread starter Jack3M
- Start date
Help Support Home Model Engine Machinist Forum:
- Joined
- Feb 20, 2010
- Messages
- 63
- Reaction score
- 13
Way to go Jack, especially liked the sound effects as the Mery died! Pretty steady up till that point. Any idea of the speed?
LMAO!!! I recognize that cry at the end!!!!
It will be like that for a bit. It will run for a bit then quit. You'll find something needs tweaking, then it will run a bit longer; rinse, lather, repeat.
It does sound like it's firing a bit out of balance. I didn't slow the video down to determine which side is weaker but you can do that. The video capabilities now are great for slowing down time and seeing what's happening. Check your compression balance and look for leaks. Especially on the rear packing.
It will be like that for a bit. It will run for a bit then quit. You'll find something needs tweaking, then it will run a bit longer; rinse, lather, repeat.
It does sound like it's firing a bit out of balance. I didn't slow the video down to determine which side is weaker but you can do that. The video capabilities now are great for slowing down time and seeing what's happening. Check your compression balance and look for leaks. Especially on the rear packing.
Oh no... That sux!
I've always done 1 piece cranks. I guess there are pluses and minuses to each.
You may want to look into timing? The power stroke may be a bit too early and resulting in a more violent stroke. Since you aren't really powering anything, there's no need to fire too much earlier than TDC.
I've always done 1 piece cranks. I guess there are pluses and minuses to each.
You may want to look into timing? The power stroke may be a bit too early and resulting in a more violent stroke. Since you aren't really powering anything, there's no need to fire too much earlier than TDC.
Jack3M
Well-Known Member
- Joined
- Jul 11, 2017
- Messages
- 294
- Reaction score
- 140
That is where I guess the timing to be, TDC Using the timing light on the ign and visual on piston location/crank. I am pretty much lousy on working steel with any kind of decent finish. Did you start with 5/8" for your one piece?
Yes, 5/8".
That was one of the parts I documented pretty well. http://www.teqknow.com/Shop/Mery2.html about 1/2 way down. Just take your time. I've seen your work you got this one. It LOOKS much harder than it actually is.
That was one of the parts I documented pretty well. http://www.teqknow.com/Shop/Mery2.html about 1/2 way down. Just take your time. I've seen your work you got this one. It LOOKS much harder than it actually is.
Cogsy
Well-Known Member
What ignition are you using? The REXEL types have built-in automatic advance and fire way advanced at even slow running speed compared to turning over by hand (I've been caught out before).
Philipintexas
Well-Known Member
- Joined
- Apr 13, 2012
- Messages
- 227
- Reaction score
- 52
I have a piece of 1” X 10” CRS left over from my Mery, I have about $10 in it but shipping would probably be prohibitive. I’m in zip 75154 is it will help.
