Horizontal or vertical
- Thread starter Ukko
- Start date
Help Support Home Model Engine Machinist Forum:
Make it adjustable.
Here are some of mine, same basic engine of 10mm bore X 20mm stroke.
Just a few pieces swapped over and they can be either.
By adding the gear for the horizontal, with string wrapped around the shaft, it will easily lift a house brick off the floor with only about 4 or 5psi through it.
Sorry this is about steam, but you should be able to do the same sort of thing with i/c.
John
Here are some of mine, same basic engine of 10mm bore X 20mm stroke.
Just a few pieces swapped over and they can be either.
By adding the gear for the horizontal, with string wrapped around the shaft, it will easily lift a house brick off the floor with only about 4 or 5psi through it.
Sorry this is about steam, but you should be able to do the same sort of thing with i/c.
John
Last edited:
Similar threads
