Wallaby

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Whoa Nellie Belle!! Way to go Pete! I must have been asleep at the wheel or something, I 'missed' the last two pages of posts ??? Man, that is a sweet model you got going there and I can only imagine the ear to ear grin it gives you (or is hat a residual effect of the HT gods? ;D)
VERY nicely done, now I'm going back and review this thread from its beginnings in case I missed something else. Sweet, sweet, sweet. Thm:

BC1
Jim
 

Congratulations Pete!

A real beauty. Thanks for taking the time to share the progress.
 
There are couple of little things I want to do to the Wallaby at my leasure, for instance before I run her again I want to set the rockers using feeler gauges and remove the throttle bush to compare rev rates.
The RC carby has a throttle hole of approx .216 and reved higher then my carby with a bushed hole of approx .190
I am mildly curious to see how it runs with the .250 of the original Sea lion design, but I feel the low compression and mild valve timing of the Wallaby may not need the extra air flow, she is after all a tractor not a race car. ;D
Pete
 
Just An update guys
I have just come into the possesion of the original Carby Article for the Wallaby and may decide to build it in the future, of course that would leave me with a working Sea lion carby.
ummmm :noidea:
anybody out there got the Sea lion Articles :big: :big:
Pete
TheWallaby-1.jpg


theWallaby-1.jpg
 
Last edited:
many thanks Ron
Ive sent you some Karma for your kindness Thm:
Pete
 

Latest posts

Back
Top