Hi, I bought one of these kits on ebay with the plans. However I have misplaced the plans..... oops. Is there any chance I can get a copy of yours?
Thanks,
Matt
Model engine builder magazine had the plans in one issue. Also a lot of the motor boys plans ie. The 2 books are on rclibrary.com. I dont think the mills was one of those though
I'm really not sure where it's leaking I know it comes out the gear cover but that's my fault( I need to make an oring to seal the shaft, I screwed up the original casting and 3d printed a new one with a modification to removel the miter gears.)
I think it is leaking out the bottom part of the...
I believe you are correct that it was special, mine is flat. you had helped me with mine a few years back before when my account name was matterest. My engine does not run as well as yours tho
I have been messaging back and forth with Steve hucks he agreed with me after a little trouble shooting that it is the can shaft. When I go the engine apart and the cam shaft out the cams for cylinder 4 were way way off like more than 100deg off. I'm lucky that the cams were just loc tited...
it shouldnt matter where it is in rotation, because it is being rotated with a starter/drill. i could be wrong but i dont think have the exhaust valve taking air in is correct.
No, if I turn it one way and put a finger over the exhaust of cylinder 1 and 4 it will suck air/finger in if I turn it the other way doing the same thing it pushes air/finger out which is probably ok, except that the other 2 cylinders are the opposite. I probably didn't word it very well the...