Recent content by vedoula

probably not an HF unit then... Makita? [tom from anastasia'a account]

do you mean a reciprocating saw?

Oh, I do see its for real... I just have too many unknown words... :D tom in MA (from anastasia's account)

very nice. did you quantify runout? take care, tom in MA (from anastasia's account)

i think the admins stated they would use the time zone in the profile they assume it's accurately stated and that the person is not traveling this is a good assumption overall

thank you very very much for these pointers! tom (from anastasia's account) in MA

is the lathe a taig? How do you like it?

yes, please I'd like to see photos! take care, tom in MA

Yes Jerry Kieffer is like a normal machinist but from another planet...

oh no!

thanks, I'll follow this suggestion.

neat shop!

Not sure if this is the correct home for this post... I am setting up a variable frequency drive, VFD, to drive a 3-phase motor of a new old lathe. I would like to put a circuit breaker before the VFD. The input is single phase - there is a single hot wire, a neutral, and the ground...

people are happy with it I hear. I do not have this mill (I have a smaller one from Sherline) -- so cannot comment. How much do these go for usually?

very nice! Tell me you sell plans for that!