Last night I completed work on the Hand Holds which are mounted to the top of the End Sills. This would be my first bit of soldering on this loco.
Being that I will be using a great deal of stainless steel and brass, I had to find the right kind of solder to do the job.
I finally came upon...
The coupler Draw Heads came next.
This was by far the trickiest CNC work I had done to date on this Loco.
They came out really cool looking.
Here is the Base Plate.
After a long break with this project I have picked it back up and am hitting it hard once again.
With the Frame Rails completed I worked on completing the End Brackets next.
Progress on the dyno is coming along great today. :)
This can be set up in two different modes.
The first is the flywheel only for recording the motor data while in compressed air mode.
I can then bolt on the electric motor module for testing and break in.
This will also allow me to...
Worked on the upper block section today.
The bearings lined up really nice and the shaft rotates very smoothly.
It will be ready for a touch of Hemi Orange tomorrow.
Well I finally made some good progress with this engine.
The first shot below is of the CAD assembly and the next two are of the actual
parts completed thus far. Yes..you heard that right. Actual parts. :)
Now with the foundation of the engine completed and mounted up all nice and sturdy,
I...