I think the timing is key to make this run better. I would be inclined to have the valve shut a little before the bottom of the stroke that would add some vacumn to the power stroke and assist with that stroke.
Thank you Apprentice and Norman. I looked up the George Thomas Staking Tool and to me it looks kind of light duty to use as a milling machine, I'm probably wrong here. It looks like an Arbour, drill press combination which would be more useful and accurate than press fitting pieces in a vise...
The cylinder went well and the head is in the rough stages. I drilled five holes in the head and cylinder and was in the process of tapping the last hole in the cylinder while saying in my head "don't break don't break" of course when I'm almost done the tap breaks off in the hole. Once the...
Apprentice that looks like a really good conversion and fairly simple too. I'm getting a Skil drill press and I think I will convert that instead of my Canadian tire light duty drill press.
Any pictures of that Ford motor? I can see where the main bearings would keep spindle deflection to a bare minimum. Another bone to chew on. I'm actually looking at possibly getting a EMCO 3 Lathe with milling attachment still waiting for the guy selling to get back to me. What are your thoughts...
Finished learning how to cut that particular cylinder a lesson I hope I don't forget before I discover a new way to botch things up. One thing that is essential for an El Cheapo milling machine is a good set of files as you can see from the last picture. So far this looks good, I'll keep you...
Milling the valve face on the cylinder. I am learning just what my El Cheapo milling machine can do. First lesson do not place work in a vice that will allow the work to roll or tip, hence the awful first cuts. 2. Have an accurate way to measure how deep your cuts are (next thing to fix)...
Found a piece of aluminium that was round and drilled out to 5/8 of and inch I then finished the bore till it was shiny. I started machining the fins on the cylinder next. Because I didn't have a centre point big enough for the bore I couldn't use mine, the cutting bit grabbed and pushed the...