Recent content by RCW

Although I am a relative newbie, here are two things that I think I can pass along safely. I am just starting to get into machining. But I have had a shop of sorts for years, and that shop has often been frustrating, particularly finding stuff. Now that I am a little older--and hopefully...

I am in awe of your workmanship. --Bob

Thanks. I appreciate your suggestion and your candor. I'm an expert "not knower!" Bob

Love your Charlie Brown forum name! Thanks, Ian, for the information. Did you happen to order this vise? http://www.ebay.com/itm/310371390946?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 If so, what did you think of it? If not, does it look OK? Many people have given me advice...

Some months ago I bought a Shars 1/2 inch drill chuck with an integral NMTB 40 shank from this vendor. It was far cheaper than anyone else, and I was apprehensive. When it arrived I was relieved. It has almost no run out, and the fit and finish are superb. I am very pleased with it. I also...

.. and keep filing reports, with pictures! Beautiful workmanship. --Bob

Give us an update if convenient. Thanks! Bob

Has anyone built this engine? http://www.john-tom.com/MyPlans/SteamPlans2/ME%20Compound%20Condensing%201923/ME1923CompoundCondensingEngine.pdf

I asume that motor is long gone, but I'd kinda like to know any detail you might remember. HP? Washer model number? Thanks!