Help Support Home Model Engine Machinist Forum:
-
-
PPaul T replied to the thread 3 cyl build.The 36 is the idler gear the crank is 22 tooth and the cam is 44 tooth.
-
PPaul T replied to the thread 3 cyl build.Oil pan casting had some sand pullout due to not enough tamping and not enough sanding of pattern.
-
-
PPaul T replied to the thread 3 cyl build.Cam lobes cut out and loose mounted to shaft they will be loctited to shaft
-
-
PPaul T replied to the thread 3 cyl build.24 dp timing gears , patterns, bronze castings, cutting, finished 22 tooth and 36 tooth
-
-
PPaul T replied to the thread 3 cyl build.It is not based on any specific engine but the pistons and connecting rod patterns are from a previous Gem 1 build. Overall size is the...
-
PPaul T replied to the thread 3 cyl build.Pictures of crankshaft silver soldered will drill and pin to main shaft and webs
-
-
PPaul T replied to the thread 3 cyl build.Have some other pictures of in process but this is build to this point
-
PPaul T replied to the thread 3 cyl build.Main bearing ,timing gears, water jacket manifold castings (silicone bronze)
-
-
-
Loading…
-
Loading…
