Recent content by messe

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    solenoid plans

    Thanks guys, most helpful Mike
  2. M

    solenoid plans

    Looking for model solenoid engine plans any scale, Need help Mike
  3. M

    tet tubes

    Help- Need information on cutting glass test tubes. Any advice at all will help Mike
  4. M

    Magnet Stirling

    Thanks everyone for the good info. E-Bay looks like my best bet. Thanks again Mike
  5. M

    Magnet Stirling

    Want to build Jan Ridders Magnet Stirling, but where can I get the magnets. Thanks Mike
  6. M

    glass cutter

    Has anyone used the glass tube cutter from McMaster- Carr. Will be cutting Pyrex test tubes. Thganks Mike
  7. M

    Test tube source for Jan Ridders coffee cup stirling

    Has anyone ever used the glass tubing cutter from McMaster- Carr. Any info. will help Mike
  8. M

    Right Angle Transmission Desktop Model

    This sure looks like a "Almond drive". Not sure of the spelling. It was to replace the noisy bevel gears in line shafts and other uses. If you GOOGLE it you should get several. Mike
  9. M

    Graphite piston material?

    McMaster-Carr has it in 12 inch lengths. Mike
  10. M

    Copper fittings

    Have some 1/8 od x 1/16 id copper tubing and have been unable to locate soldering fittings such as elbow and tee fittings. Have seen these on small engines. Can anyone help. Thanks mike
  11. M

    Fuel

    Thanks for all the info. Will not use Acetone under any conditions as a fuel. This group again has saved me from disaster. Mike
  12. M

    Fuel

    Has anyone ever used Acetone for fuel in a 4-stroke gas engine. Your comments and tip are welcome. Thanks in advance. Mike Esse
  13. M

    Vidio Grasshopper engine

    My 1/2 scale model of Roy Ozouf's grasshopper crosshead engine. 7/16 bore x 3/4 stroke. All dim. were held, just changed some looks to suit my own tastes. Very good runner on 3# of air. Mike http://www.youtube.com/watch?v=Q7NvGg6cfMQ&feature=youtu.be
  14. M

    lathe for sale

    Have a 7x12 lathe for sale. Purchased from Cummings Supply, made in China. Almost new, about 3 hrs.total. many accessories. PICKUP ONLY. I am in the Los Angles area. If interested contact me for photos and price. [email protected] Mike
  15. M

    Boyar Schultz surface grinder?

    ANDREW, I have used these grinders for over fifty yrs. Check the spindle. A Pope is the best and Excelsior is second choice.Everything else can be repaired easily. Hope this helps Mike
Back
Top