Recent content by mattty

Hi , I am close to finishing this engine, could someone help me out with what "o ring" size I need to order for the piston. Thanks Matt

Hi John , great looking engine. what kit is it? and where would I order one from. Thanks Matt

Help needed for a replacement drive belt. I have just purchase a milling machine. I believe its a sieg x3, I have stripped the drive belt (timing belt) its 415mm long and I think it had 65 teeth but because there a teeth missing I cant be 100 percent sure on the 65 teeth number. does anyone...

I love the Brake, do you have a link for the brake you bought, I want to put one on my HAFCO lathe. Thanks Matt

Excellent , thanks mate.

Good morning, I am after a set of these plans, but am unable to locate them, could somebody steer me in the wright direction. Kind regards Matt

Looking forward to watching this build. I would be keen to see some photos of your taper turning attachment. good luck Matt

Thanks Paul

Thanks Brian, I will start shopping.

Also, I will be using a R/C carburettor , what would be the best size to buy.

I have finally found some "shed time" and got back into my Webster build. I have 2 questions. firstly , where can I source the gears (I am located in NSW Australia) Secondly , the Viton orings for the piston rings , do I buy them in a kit or is it acceptable to cut and glue the oring. also...

John (blogwitch) , your workshop looks very impressive. I like the air ratchet set-up. Matt

nice work, great looking engine.

excellent information, thank you for the feed back to my question.

I am following this thread with interest , I have slowly been tooling up in my workshop, and I am almost ready to cut gears for the websters engine , then Brains 2 stroke engine. I have just found these cutters on ebay and the seller is in the same area as me. would they be suitable for cutting...