Recent content by Jennifer Edwards

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Jennifer Edwards

    Arduino RPM Application for Sieg Lathes and Mills

    Thank you for following up! It is appreciated.
  2. Jennifer Edwards

    Big Old Lathe For Restoration

    Hi, I am selling this for a friend. It lives in his garage here in Bridlington, England. It measures 36+ inches between centres possible even 40 inches with the tailstock in place. It has a swing of six inches over the bed (12" in diameter). There is a single phase 430 volt motor and a system...
  3. Jennifer Edwards

    Arduino RPM Application for Sieg Lathes and Mills

    Hi Bob, In response to your statement: “I have yet to solve. I can start and stop but controlling the rpm is not there yet. There is pages on other boards on the subject.” I thought about controlling speed by replacing the potentiometer used now to manually control the speed with a voltage...
  4. Jennifer Edwards

    Bugatti straight 8 cylinder with blower, design, 3D printed molds, castings , machining, assembly

    Hi Jules, at the time I was about 12 years old, I’m noW 64, and unfortunately if there are any surviving photographs they ar3 not in my possession. to describe it a bit more: it was a flathead motor. I’m not sure what year the motor was, most likely early 50’s if I had to guess. I do know...
  5. Jennifer Edwards

    Arduino RPM Application for Sieg Lathes and Mills

    Just an update, Since first posting this project I have had over forty people who have contacted me for the code or advice complete this project. some have successfully used the Arduino “Nano” boards and were able to contain everything inside the existing housing of their lathes and mills...
  6. Jennifer Edwards

    Need "Pinout" for Sieg SC2 Lathe R.P.M. socket

    Since posting this project I have had over forty people successfully build this project. some used the Arduino “Nano” boards and were able to contain everything inside the existing lathe or mill cabinet. thank you everyone who has requested the code or some help with their builds. I have been...
  7. Jennifer Edwards

    Bugatti straight 8 cylinder with blower, design, 3D printed molds, castings , machining, assembly

    Your post has reminded me of my youth when I helped my father build a Buick straight eight with eight little Webber carb. We mounted it in an old “rail” dragster frame he had and took it to the track. I remember well the roar it made as he drove it. good luck with your model
  8. Jennifer Edwards

    Arduino RPM Application for Sieg Lathes and Mills

    please share what you learn about using the touch screen with us. My next step was to integrate an input device so one could enter a material and It’s diameter then have the program suggest a speed. too bad the controller will not accept a digital speed input. If it could, and I’m not sure it...
  9. Jennifer Edwards

    Complete Model Engineering Shop

    Yes I’m sorry to pack it in but glad it went to a home where it will be put to good use and not just parted out for profit. Thank you for the good wishes and rest assured I will still be here. MERRY CHRISTMAS!
  10. Jennifer Edwards

    Complete Model Engineering Shop

    It has been sold! THANK YOU ALEX!
  11. Jennifer Edwards

    Complete Model Engineering Shop

    I’m dropping my price to £1500 or best offer. I just want to see my shop go to a good home where it will be used as intended.
  12. Jennifer Edwards

    Complete Model Engineering Shop

    Thanks Jos, I really appreciate that, Let them know I will accept any reasonable offer. I just want to see the equipment go to a good home. Jenny
Back
Top