Jack3M's Recent Activity

Help Support HMEM by donating:

  1. Jack3M replied to the thread Mery 6-stroke kit..

    Forgot to mention since I plan on pressing the sleeve in again, going to taper one end .002" over 1" to help get a straight start.

    Jun 15, 2019 at 3:58 PM
  2. Jack3M attached a file to the thread Mery 6-stroke kit..

    Thinkin' maybe I jumped over some steps in describing this process of the cylinder sleeve. First, to get an average indicated center...

    20190614_134246.jpg 20190615_054415.jpg Jun 15, 2019 at 1:55 PM
  3. Jack3M attached a file to the thread Mery 6-stroke kit..

    Welllllll, I goofed up. Made a really stupid mistake and not sure how I got my mind set on the wrong internal diameter, but I did, then...

    20190613_102902.jpg Jun 14, 2019 at 4:26 PM
  4. Jack3M attached a file to the thread Mery 6-stroke kit..

    Boring can be boring....pun intended. Think I learned something and would like comments. The big boring bar was too large to start...

    20190611_134419.jpg Jun 11, 2019 at 10:27 PM
  5. Jack3M attached a file to the thread Mery 6-stroke kit..

    Today the sleeve was installed in the cylinder and began boring that. Kind of a make sure you do some things first section, as in the...

    20190610_091646.jpg 20190610_125525.jpg 20190610_143612.jpg 20190610_155120.jpg Jun 11, 2019 at 12:47 AM