Recent content by HS93

this is metric but may not be of any use but a lot cheaper they do have other chain http://www.technobotsonline.com/steel-roller-chain-04b-6mm-m.html Peter

tried several times to join your forum and it just regects my passcode can you help, could not even leave a message as it just sat there Peter

where did you get the stepper controller unit in the bottom picture thanks Peter

Being a Joiner by trade not a metal basher I leave my stones on the window cill and the odd day it is not raining in the UK and we get the yellow thing in the sky I find the warmth tends to make it sweat and it brings any deposits up to the surface, I then re oil with 3 in 1 oil a light machine...

welcome George nice to see you posting on hear, Peter

Ahh OC71 s if you scraped the black paint off you could make a light activated switch , they where a big change to playing with Xtal sets. Peter

That's better,nice engine what are you going to put it in radio gear is so light these days it would make it practical to use RC. Peter

and it's invisable ;D Peter sorry cannot see the picture

Hi I am hoping to do this conversion but I am having difficulty working out how to get the drive to the pulley from the gear below I can see that it must be via the piece I have arrowed but how does this part connect to the gear below or have you internally splined this part marked with an arrow...

Have you seen these they will take 50v , I have had a few for boats for a few years and they are one of the only speed controllers that have a repair service, and for you American made http://www.castlecreations.com/products/phoenix-ice2-hv.html Peter

I have the smaller version of yours, the warco WM14 that I would like to change the drive motor as it overheats at full speed using fine cutters, have you got any more information on the main drive system motor you are using and the gear ratio thanks Peter

Stew do you make wedding cakes?? :big: :big: Peter ;D

nice job I have just fitted some that came originally from the same site but on the front as I have a small table and need all the movement I can get. have you decided on covers yet to stop swarf getting in to the scales? I have fitted one cover that I got in the uk but have to fit the other as...

Nice Ill try that on my mill Thanks Peter

engines, sorry mine are not as good as Johns http://www.youtube.com/watch?v=JjE4BDu13rA&list=UUG0Gyq428U6zApceCges1Pg&index=1&feature=plcp http://www.youtube.com/watch?v=k4pVgOKdKPY&list=UUG0Gyq428U6zApceCges1Pg&index=2&feature=plcp Peter