Hello I make points quite often I use 1/8 Tig electrodes I just slice off 1/16 discs. But more than often I use point sets that where used in a car that was popular in 1950 it"s name was Crosley little Like the Mini. for us colonist Whiteny auto part have them. sets come in two pieces an...
I just fell heir to a 6300 Clausing lathe. I has been siting under a cover for 50 years. So dry I oiled it left sit 12hr. oiled it again. The oil in the head stock looked new . so I just turned by hand for about 10 min. then started it, as smooth as velvet. Let run for 15 min. could not wait...
Thanks for so much help. With a I cheated on the computer I made 222 divided print out then mount it disk ali put direct index cut the segment of teeth needed for what I needed work thank for all you'r help. In the future I will set the mill and the dividing head up lock door and just go one...
I have a 7.00 dia. that needs 222 teeth 32 d/p I"m lost I would like to learn how to do the calculations What hole plate and turns and holes Best Regards Red redcraftm
Hello Zeb I'M back I told you about some of some experience with the Day Light. So I thought OF movie That came out in 1986 staring Burt Lancaster and Kirk Douglas fun movie , But some great scenes, A lot was shot in the desert here in CA. Good luck. Best Regards Red
Hello I had the good fortune too Know MR Dick Preast he built a11/2 scale with cars too sit 4to 6 people . Little Engine of Lomta CA. casting .Regrettable long gone.The engine was oil fired steel boiler rolled and beaded flues I helped to reflue the boiler in 1965 after 15 yrs. of lots of steam...
Good morning Matterest: I'm sorry I did't go into a little more detail. What I use for a punch is 1/16 dia music wire with a flat end, then lightly tap and pack the teflon in until it is tight. I've had to do this a number of times with these casting always in the same ex. port some time the...
Maiierst. I have Wall 4 that I run a 5' R/C boat that had the same problem. I cleaned it out then took a 1/16 dia. punch and packed teflon tape in, That is tapped it in This was 56 yrs. ago. I have run this boat yr. after yr. Capt,n John has seen a video of it runnig. I have made a number of...