Hello i liked your build, i ordered your boards (4.1 version). i started to build and ran into interference between nano and other board. also what type of connector were u planning on using for motor connector. The pin spacing is too wide and too narrow for the different connectors. pictures...
thanks for the info. i ended having to uninstall all arduino files and start fresh.after i downloaded the file, timer1 file was missing . The program runs. i have a sainsmart lcd, so some buttons aren't working i have to check it out.
thanks
Hello I have been a avid reader of this forum. i have downloaded chuck fellows program as well as others to see what suits my needs. i am trying to run rotary table chuck 10 it is missing a file "GetMicroField.h" i have not been able to locate in the other earlier files on the forum i tried all...