You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
E
Thanks for the welcome messages I received after becoming a member yesterday. I mentioned in my introduction that I was currently...
-
E
There is a Live stream:
Ohio, Armstrong Museum.
https://www.youtube.com/embed/IXkaBdVQfFA?wmode=opaque&start=0
The next total solar...
-
E
It took an extra 2 hours to go the last 30 miles home.
All the folks apparently traveled west on I-40, and then went north or south on...
-
E
Crystal clear weather here.
Spectacular event.
Very impressive, and very odd to see the sun just fade out like that, and it becomes very...
-
E
The eclipse rolled through here in Texas. We were lucky in that we could watch it from the home driveway. No traveling needed. It was...
-
E
Lots or apocalyptic rumors going around about millions of people descending upon small rural towns, created a sort of Woodstock II...
-
E
Four brass cam lobes with set screws.
I also made up the timing belt tensioner and set the exhaust valve timing.
Another view.
I...
-
E
I muddled over how to line bore the main bearing caps for some time with the equipment and tooling I had and finally decided on this...
-
E
The only markings on the shank are the mfr. name/location and the pitch marking of 26 tpi. It's taper is similar to a pipe tap. The...
-
E
Thanks Ken I will keep that in mind.
I fully intended to document the assembly of the crankshaft but in the heat of things I completely...
-
E
The kitchen remodel project is winding down and I have gotten some time to work in the shop again.
I will try to build a crankshaft...
-
E
I was able to get some time over the last few days from my (she who must be obeyed) remodeling job to make a big mess and a cavity...
-
E
I understand now thank you for asking.
I make it up as I go along.
Sometimes that's good and sometimes I have to start over but always...
-
E
I am not sure I understand your question gbritnell.
I have seen round crankshafts pressed together and then drilled and locked in...
-
E
Well it's been 26 days since I finished my 4 cyl boxer engine and I am having withdrawal jitters so time for another engine build. This...