I now found it but, the E-bay says that does not send to Brazil.
I'm interested on those magazines. Could you sell it directly to me?...
I did that. I installed the heads back on the block, without the pistons and crankshaft.
I used a Dremel to spin the pump shaft. I found...
I search for that but did not showed up.
I'm getting water on the oil pan and I can't find where it is leaking. Scratching my head!!!!!
I already sealed the OD of the liners to the...
That's OK Awake. Don't mind!
Thanks for the words, I'm still learning with the great people here.
You are absolutely right. It is getting more stable running every day. It already showed some idle.
Tomorrow I will post the new video....
I touched the PeeWee this evening again.
I advanced the distributor to around 35 degrees and it started to respond to the throttle...
I found that it runs better with the distributor advanced about 10 degrees.
It is still not responding to the throttle, maybe some modifications...
After many attempts to start the PeeWee, I gave up and decided to tear it apart for a complete checking of the components.
I did not...
Congratulations! Top Noch project and work.
Very nice low idle.
Also interested in the plans.
Thank you for the Photos. That is the same process I'm using on my PeeWee V4 but the hole is getting about 0,02mm tapered. I remember...
Great work, congratulations! You are progressing fast.
Could you post some pictures of your lapping tool and also how you used it?...
I understand your comment I agree.
Take a look at the manual to know if it has understandable English for you....
Take a look at this one. I'm using it on my tabletop milling machine, (you do not need a computer, it is a stand-alone controller). Workes...
Hi to all!
I'm in dought about the correct firing order of the PeeWee.
Is it 1-3-4-2 or 1-3-2-4?
I found the two information on Bob's drawing...
Separate names with a comma.