Recent content by Cornnatron

Need is a big word its more cause thats what i got on the shelf left over from a 3d printer its a 128x64 grapiclcd with intergrated rotary encoder. Got some 20x2 and 16x2 screens aswell but am lacking the 4x4 buttons . And i got the screen working with the demo sketches but need to write it in...

What kind of lcd are u using ? Cause im trying to get a fork of this to work with the 128x64 grapiclcd which is also hard. Could i maybe get a copy of yours to see how they implemented it ? My lcd uses the u8g2 or u8glib lib. Then i just have to work on getting it compatable and work out the...

After reading this i remember again that that was about the explaination i had read when i was busy with grbl and the nano. Couple of years back , i forgot most just that there where isues with the ch340, but reading your explaination brought it all back lol. Now i can forget about it again for...

Strange but like i said a never run in to that problem but knew there was something with those 340 chips, could also just be you got a bad batch i once got a small batch of nano which came without usbmicro ports installed , it was a hell to order the right usb ports where the board was designd...

But like stragen sayed it mostlikely is the preinstalled bootloader on the cheap chinese clones and if i got the right one that problem sticks its head up on ch340 chipsets .

Me neither though i do know that there are different chipset availble like the atmega328p or the ch340 or something do all the same spec wise but some got some times issues with uploading or running. Remember something beeing talked about that around grbl.

Cheers for that nice project , did leaf me a bit of a question though what about the nano lol, you refer to get back to it later a couple of times but never did come to it. Or i didnt see it lol. And about the 2x20 or 4x20 isnt the problem i could just order one if needed but im like you ,love...

got one of those tools too which works for the end of the stock but harder for say a very small concave or convex along the lenght of the stock

Next on the list is gonna be a els clough42 based , was considering going full cnc with encoders as handwheels but i love the real feel of the turning and you lose that . Would be awsome for concave and convecs or taper turning but that isnt needed for now.lol. And why encoders as handwheels if...

Here you go aint finished yet but atleast something still got to work on the electronics and software but ill post some when that is finished.

Cheers have been reading through that topic and saw your post but , seeing i aint got a 20x4 screen here jet but got some 128x64 graphic screens with a rotary switch left over from some 3d printer ill try to implant that to it. Some do have to change a bit of code first. But shouldnt be to much...

Installed when needed and removed for normal running.

The rotary table iz getting connected to the lathe spindle on the troughhole side so its possible to rotate the spindle to any angle

Thanks for the plans a bit to complex jet but will keep for when im a bid more advanced. Gonna drive the spindle with it thats the easyest option , seeing the center of the rotary aint in the center of the rear housing . Second my lathe aint got a spindle lock yet. So i would have to chuck it...

Cheers for that ill surely have a look at those. At first ill look at steamers. Cause they are a bit more simple and i am still just a starter in this stuff , only got a lathe since 2 months a cq6133. And never turned any metal except twistdrills and nuts and bolts and screws before that. and...