Recent content by Brian Peters

clean the plastic very well to remove all grease rough up the interior of the shaft hole in the gear very well with 60 or 40 grit paper place the gear flat on waxed paper and fill the whole with well mixed JB weld NOT JB Quick allow to cure at room temp for 48 hours then re machine the bore...

Please Sir can I have some more?

sorry about the redundant answer to a problem on page 2 lol will get the hang of this soon only respond to the end of the thread Durp as my son would say

up .25 is correct but to be 0.25 off the diagonal line which looks like 60 not 90 to the horizontal line you would need to calculate the offset to the right as right = cos(60) x 0.25 = 0.125 should get you there if I still remember how to do trig.

Here are a couple of pictures

Hi I am seeking someone who owns a Central Machinery 590 Mill Drill and has the manual I recently purchased a used one originally built in Tiawan in 1986. It is in apparently great shape but I don't have a manual for it and would gladly pay for a copy if someone here has one.