Recent content by BluSky

Hello, I made this engine from that kit approx 25 years ago. In my kit the lattice pillars which are placed on both sides of the cylinder were made of laser cut metal sheet and soldered with flanges etc. The cylinder was a cast part. I manufactured the curved cylinder hole by using a round...

Hello Tony, unfortunatelly I discovered the bug first when I had already drilled the holes. I discussed the situation with TS. He recommended to shorten the cam hub a little to cope with the gap resulting also in a bigger cam edge. Otherwise I would have to manufacture a new bracket. I followed...

Hello Edward, I have also build this engine with castings from Thorsten Schuer. May I draw your attention to a bug in the drawings (at least my copy) relating the camshaft bracket. The distance between camshaft center and center of the outlet lever pin (Auslasshebel) is too small given on the...